Description
USES
ROCKSTAR SPRAY SEAL is suited to tile, stone and grout surfaces. Protects and seals: terracotta, granite, sandstone, aggregate stone, porcelain, grout, marble, limestone.
BENEFITS
-
Quickly penetrates surfaces and inhibits stain absorption
-
Simple, safe and easy spray sealant application
-
Non yellowing and UV resistant
APPLICATION INSTRUCTIONS
1. Always test on a small inconspicuous area first.
2. Ensure the surface to be sealed is clean, dry and free of any oils, paint, grease, traces of grout and other surface contaminants.
3. Spray ROCKSTAR SPRAY SEAL to the area in a sweeping action from a distance of approximately 15-20cm away.
4. A second application may be applied after 4 hours.
5. Allow 24 hours for sealant to fully cure before allowing full use of the treated area.
COVERAGE: Between 10-18m2 per can depending on the porosity of the surface.
ROUTINE CLEANING: To preserve maximum efficiency we recommend using Rockstar Neutral Stone Cleaner or Rockstar Stone Clean Plus for all routine cleaning of grout, tile surfaces.
PACKAGING: ROCKSTAR SPRAY SEAL is available in 300g aerosol can.
SAFETY
ROCKSTAR SPRAY SEAL should only be used in an open or well ventilated area, or when a suitable respirator is worn. Any spill should be removed immediately to minimise absorption.
CAUTION: HIGHY FLAMMABLE. Do not pierce or burn even when empty. Dispose of in garbage or at an appropriate recycling collection point. Store below 50ºC. Do not spray on naked flame.
DISCLAIMER
The advice and information contained herein is based on our best knowledge of the product. We believe the information to be accurate and reliable as at the date supplied, but no representation, guarantee or warranty, expressed or implied, is made to the accuracy, reliability, or completeness of the advice and information. We urge persons receiving this advice and information to make their own determination as to the advice and information’s suitability and completeness for their own particular situation. When in doubt it is always prudent to perform a trial on a scrap section of material, or inconspicuous section of the job to ascertain the products suitability.
